|
 |
You are viewing:
Furnaces / Heaters
> Forced Air
> Standard Homes
> Natural Gas / LP
> 95% Efficiency
> Multi-Speed Blower, Two-Stage Burner
> Goodman GMH950905DX Gas Furnace
|
 |
|
|
 |
Goodman GMH950905DX Gas Furnace
|
92,000 BTU Furnace, 95% Efficiency, 2-Stage Burner, 2,000 CFM Multi-Speed Blower, Upflow/Horizontal Flow Application
|
|
|
 |
 |
ON SALE! $1,592.99
Compare to: $2,087.99
You save: $495.00
|
 |
|
See additional images
|
 |
     |
 |
|
The Goodman® GMH95 95% AFUE Two-Stage (Convertible), Multi-Speed, Multi-Position gas furnace features a patented aluminized-steel tubular heat exchanger and durable Silicon Nitride Hot Surface Ignition system. This furnace is run-tested for heating or combination heating/cooling applications. (Please read this Important Safety Notice) Standard Features - Operates as a natural gas furnace out of the box, and can be easily converted to a propane furnace with optional propane conversion kit (see "accessories" tab).
- Patented TuffTube™ dual-diameter tubular furnace heat exchanger with lifetime limited warranty plus 10-year furnace replacement limited warranty*
- Two-stage furnace gas valve with revolutionary new Dual$aver control technology that allows installer to turn on two-stage operation with the flip of a dipswitch
- Silicon Nitride igniter with patented adaptive learning routine for maximum igniter life
- Energy-saving, quiet four-speed direct-drive circulator blower motor
- Integrated electronic Goodman furnace control board with self-diagnostics, low-voltage terminal block, and separate terminals for electronic air cleaner and 24-volt humidifiers
- Heater's control board stores the last five diagnostic codes in memory; simple push-button activation outputs the fault history to a flashing red LED
- Low constant fan mode allows the homeowner to activate the lowest available heating speed to circulate air quietly and efficiently throughout the home during the off cycle
- Self-adjusting feature automatically adjusts furnace to high or low stage based on outside temperature without outdoor temperature sensor
- Dual-certified for sealed combustion direct vent (2-pipe) or non-direct vent (1-pipe) applications. The direct vent furnace setup uses outside air for combustion which increases comfort and furnace energy efficiency.
- Easy-to-install top venting standard; alternate flue/vent located on the right (GMH95)
- Quiet, single-speed induced-draft blower
- All of these Goodman furnace models comply with California NOx emissions standards
Cabinet Features - Fully insulated, heavy-gauge steel furnace cabinet with durable baked-enamel finish
- Furnaces' Foil-faced insulation lines the heat exchanger compartment
- Designed for multi-position installation: Goodman GMH95: upflow, horizontal left or right; Goodman GCH9: downflow, horizontal left or right
- Airtight solid bottom for side-return applications and easy-cut tabs for effortless removal in bottom air-inlet applications
- Convenient left or right connection for furnaces' gas and electric service
- Coil and furnace fit flush for most installations
A federal energy efficiency tax credit of up to $1,500 is available for this furnace if placed in service from January 1st, 2009 to December 31st, 2010. The energy tax credit covers 30% of the equipment, installation supplies and labor costs up to $1,500. Take advantage of this limited-time energy tax rebate - act today and don't miss out on these great furnace rebates!
|
High Fire Input BTU
|
92000 BTU |
|
High Fire Output BTU
|
89000 BTU |
|
Low Fire Input BTU
|
69000 BTU |
|
Low Fire Output BTU
|
66750 BTU |
|
Maximum CFM
|
2000 @ 0.5" ESP |
|
Efficiency
|
95 % |
|
Tax Credit
This product may qualify for an energy efficiency tax credit. |
Yes |
|
Blower Cooling Capacity Up To
|
5 Tons |
|
Configuration
|
Up-Flow/Horizontal-Flow |
|
Maximum Breaker Size
|
15 Amps |
|
ENERGY STAR® Qualified
|
Yes |
|
Flue Pipe Diameter
This refers to the size of the flue pipe needed, and not necessarily the actual connection size on the furnace. Flue diameter is based on length of run and number of elbows used. Please read the installation instructions carefully to ensure correct diameter flue size for your application. |
3 Inches |
|
Supply Air Opening Size
|
23 x 19.875 Inches |
|
Width
|
24.5 Inches |
|
Dimensions (WxDxH)
|
24.5W x 28.75D x 40H Inches |
|
Weight
|
172 lbs |
|
Heat Exchanger Warranty
|
Lifetime - 10 Year Furnace Replacement |
|
All Other Parts Warranty
|
10 years |
|
Meets CSA Standards
Canadian Standards Association |
Yes |
|
|
 |
 |
|
 |
 |