(800)865-5931 Monday to Friday 8:30 AM - 5:00 PM Central
0
Free Shipping See Details
|
No Sales Tax See Details
The Emerson 5464 has been discontinued.
TRY THIS INSTEAD
Please call us for a suitable alternate product.

(800) 865-5931

Monday - Friday

8:30 AM - 5:00 PM Central

These 2-speed 5.6" (diameter) totally enclosed multi-horsepower replacement condenser fan motors can run in all positions and can be used to replace most 1/3, 1/4, 1/5, and 1/6 HP motors. These replacement motors can be wired for 3 or 4 wire capacitor hook ups. Also, these motors are quickly reversible by switching the yellow and blue leads. Our replacement motors come with several standard features, which include:

  • 2 speed: 825rpm
  • Automatic thermal overload
  • Ball bearings
  • 36" leads
  • Counter Clock Wise Lead End (CCWLE)
  • Reversible
  • Uses 5.0 Microfarad (MFD) or 7.5 Microfarad (MFD) 370 volt capacitor (not furnished)
  • 4 holes in shell for mounting
  • Shaft up or down

Speed(s)

The number of speeds a motor runs at. Motors with 4 speeds can run at High, Medium High, Medium Low, and Low. Motors with 2 speeds can run at either high or low speed.

Speed(s)
2
Horse Power

The amount of power generated by the motor. One horsepower (HP) is equivalent to 746 watts.

Horse Power
1/3 - 1/6 HP
Revolutions Per Minute

Rotational speed in revolutions per minute

Revolutions Per Minute
825 RPM
Bearing

Basic types include: Sleeve - Preferred where low noise level is important, as on fan and blower motors. Unless otherwise stated, sleeve bearing motors listed can be mounted in any position, including shaft-up or shaft-down. Ball - Used where higher load capacity, either axial or radial, is required or where shaft speed is lower than 500 RPM. Shields, metal rings with close running clearance one one side (sigle-shielded) or both sides (double-shielded) of bearing, and seals, which are similar except with rubber lips that press against inner race, more effectively excluding dirt, ect., are two barriers used to keep out dirt.

Bearing
Ball
Ambient

The temperature of the space around motor. Measured in Celcius (40 degrees celcius equals 104 F).

Ambient
60 Degree Celcius
Rotation
Reversible
Mounting

Resilient Mounting - Sometimes called rubber or hub mounted - motor shell is isolated from base by vibration absorbing material, such as rubber rings on the end shields, to reduce transmission of vibration to the housing of the unit or appliance. Stud Mounting - Motor has bolts extending from from front or rear, by which it is mounted. Often used on small, direct drive fans and blowers.

Mounting
Stud
Replaces

Type of motor this model replaces.

Replaces
825 RPM 1/3 to 1/6 H.P. Condenser Fan Motors
Shaft Dimensions

Width of the shaft (usually 1/2") x the Length of the shaft.

Shaft Dimensions
1/2 x 5 Inches
Thermal Overload Protection

A temperature or current sensing device usually integral within the motor, that disconnects the motor winding from its power source to prevent overheating due to overload or failure to start. Automatic Reset(Auto) - After Motor cools, protector automatically restores power. Should not be used where unexpected restarting would be hazardous.

Thermal Overload Protection
Auto
Voltage
208 / 230 Volts
Frequency
60 Hz

In 2002 Alpine Home Air Products became the first company to sell heating, air conditioning and indoor air-quality products online. We have proudly served hundreds of thousands of customers, helping them save time and money by buying their products direct.