(800)865-5931 Monday to Friday 8:00 AM - 5:00 PM Central
Free Shipping See Details
No Sales Tax See Details
Actual product may vary from photos.

Crown Boiler Company BWF195EN

195,000 BTU, Water Boiler, 82.3% Efficiency, Intermittent Pilot, Natural Gas / LP Convertible, Power Vented

(2 Reviews)


  • Liftgate Delivery $25
  • Shipping to Canada

    Canadian tax and shipping fees may be estimated prior to purchasing an item by completing the form below.

    Duties (%): N/A
    Canada Tax (%): N/A
    Brokerage: N/A
    Total taxes: N/A
    Quantity: Postal Code:
  • Flat Rate Returns $30
  • Pro Installation

The BWF series boiler is a cast iron gas fired boiler designed for use in forced hot water heating systems. The BWF is intended for installations where a usable chimney is not available. The BWF is normally vented using an approved vertical or horizontal AL29-4C stainless steel venting system, which is not included with the boiler. If a suitable chimney is available, the BWF series can be vented into it using an optional BWF Category I Vent Kit available from Crown. The BWF requires an adequate source of clean combustion air in the boiler room. The BWF boiler is not designed for use in gravity or “open” heating systems.

Please read this Important Safety Notice

Standard Features

  • Approved for installation on non-carpeted combustible floors
  • Cast iron heat exchanger
  • Step opening gas valve for smooth ignition
  • Supply tapping located off top of boiler
  • Integral fan for side-wall venting
  • Category III side-wall or vertical venting with AL294C stainless steel venting material
  • May be chimney vented using optional category I venting
  • Induced draft blower with pressure switch
  • Honeywell electronic ignition system with 30 second pre-purge
  • Universal vent adapter
  • High performance circulator with isolation flanges
  • Stainless steel burners
  • Pressure switch detects venting problems
  • Rollout switch detects heat exchanger blockage
  • Combination temperature/pressure gauge
  • Boiler drain
  • ASME relief valve set at 30 PSI
  • Two-tone powder coated jacket insulated with fiberglass
  • Natural gas
  • For altitudes above 2,000ft, ratings should be reduced at rate of 4% for each 1,000ft above sea level
  • Boiler must be ordered for proper elevation above sea level when being installed at altitudes above 2,000ft

Heating Capacity

The amount of heat, rated in BTUs that the item can produce.

Heating Capacity
195,000 BTU
Effective Heating Capacity (BTUs)
Water Capacity
6.3 Gallons
Net Water Rating

The amount of heat, measured in BTUs, that the unit will be able to effectively deliver into your home.

Net Water Rating
140,000 BTU
Efficiency (% AFUE)

The percentage of energy converted into output by the unit. The remaining percentage is lost during the conversion process. The higher the efficiency, the lower the operational cost.

Efficiency (% AFUE)
82.3 %
Max Vent Length- Horizontal
45 Ft
Max Vent Length- Vertical
37 Ft
Piping Connections - Water
1 1/4 Inch(es)
Dual Pipe Vent Diameter
4 inches
Product Weight
482 lbs
Meets CSA Standards

Canadian Standards Association

Meets CSA Standards
27 1/4 Inches
26 3/4 Inches
36 69/100 Inches
Cast Iron Sections Warranty
Parts Warranty
1 Years

In 2002 Alpine Home Air Products became the first company to sell heating, air conditioning and indoor air-quality products online. We have proudly served hundreds of thousands of customers, helping them save time and money by buying their products direct.