|
|
 |
|
Crown Boiler Company BWF229EN
|
229,000 BTU, Water Boiler, 82% Efficiency, Intermittent Pilot, Natural Gas/LP, Power Vented
|
|
|
The BWF series boiler is a cast iron gas fired boiler designed for use in forced hot water heating systems. The BWF is intended for installations where a usable chimney is not available. The BWF is normally vented using an approved vertical or horizontal AL29-4C stainless steel venting system, which is not included with the boiler. If a suitable chimney is available, the BWF series can be vented into it using an optional BWF Category I Vent Kit available from Crown. The BWF requires an adequate source of clean combustion air in the boiler room. The BWF boiler is not designed for use in gravity or “open” heating systems.
Please read this Important Safety Notice
Standard Features - Approved for installation on non-carpeted combustible floors
- Cast iron heat exchanger
- Step opening gas valve for smooth ignition
- Supply tapping located off top of boiler
- Integral fan for side-wall venting
- Category III side-wall or vertical venting with AL294C stainless steel venting material
- May be chimney vented using optional category I venting
- Induced draft blower with pressure switch
- Honeywell electronic ignition system with 30 second pre-purge
- Universal vent adapter
- High performance circulator with isolation flanges
- Stainless steel burners
- Pressure switch detects venting problems
- Rollout switch detects heat exchanger blockage
- Combination temperature/pressure gauge
- Boiler drain
- ASME relief valve set at 30 PSI
- Two-tone powder coated jacket insulated with fiberglass
- Natural gas
- For altitudes above 2,000ft, ratings should be reduced at rate of 4% for each 1,000ft above sea level
- Boiler must be ordered for proper elevation above sea level when being installed at altitudes above 2,000ft
|
The BWF series boiler is a cast iron gas fired boiler designed for use in forced hot water heating systems. The BWF is intended for installations where a usable chimney is not available. The BWF is normally vented using an approved vertical or horizontal AL29-4C stainless steel venting system, which is not included with the boiler. If a suitable chimney is available, the BWF series can be vented into it using an optional BWF Category I Vent Kit available from Crown. The BWF requires an adequate source of clean combustion air in the boiler room. The BWF boiler is not designed for use in gravity or “open” heating systems.
Please read this Important Safety Notice
Standard Features - Approved for installation on non-carpeted combustible floors
- Cast iron heat exchanger
- Step opening gas valve for smooth ignition
- Supply tapping located off top of boiler
- Integral fan for side-wall venting
- Category III side-wall or vertical venting with AL294C stainless steel venting material
- May be chimney vented using optional category I venting
- Induced draft blower with pressure switch
- Honeywell electronic ignition system with 30 second pre-purge
- Universal vent adapter
- High performance circulator with isolation flanges
- Stainless steel burners
- Pressure switch detects venting problems
- Rollout switch detects heat exchanger blockage
- Combination temperature/pressure gauge
- Boiler drain
- ASME relief valve set at 30 PSI
- Two-tone powder coated jacket insulated with fiberglass
- Natural gas
- For altitudes above 2,000ft, ratings should be reduced at rate of 4% for each 1,000ft above sea level
- Boiler must be ordered for proper elevation above sea level when being installed at altitudes above 2,000ft
|
|
|
|
