Lonox Emission 80,000 BTU Furnace, 95% Efficiency, 2 Stage Burner, X13 Motor, Upflow/Horizontal Flow Application
Lonox Emission 80,000 BTU Furnace, 95% Efficiency, 2 Stage Burner, X13 Motor, Upflow/Horizontal Flow Application
Model: Goodman GME950805CX
To use LP fuel, this unit requires an LP Conversion Kit. See Accessories
The Goodman GME95 95% AFUE Two-Stage (Convertible), Multi-Speed, Multi-Position Gas Furnace features a super-efficient X13 blower motor that saves electricity during the heating and cooling months. This new direct current motor uses less electricity than the standard multi-speed furnace blower. For example, in constant-fan mode, the X13 runs on an average of 110 watts, whereas a standard furnace multi-speed blower uses an average of 360 watts. This efficiency furnace also includes a patented aluminized-steel tubular heat exchanger and durable Silicon Nitride Hot Surface Ignition system. This Goodman gas furnace is run-tested for heating or combination heating/cooling applications. With a heavy-gauge, reinforced, insulated steel cabinet and durable baked enamel finish, this unit can be installed in a variety of locations.
Please read this Important Safety Notice
Standard Features
• Dual-diameter tubular heat exchanger
• Two-stage gas valve convertible technology allows installer to activate the two-stage valve with the flip of a dipswitch
• Energy-efficient multi-speed ECM motor
• 110V Silicon Nitride igniter designed for long igniter life
• Furnace control board with self-diagnostics, colorcoded low-voltage terminals, and provisions for electronic air cleaner and 24-volt humidifiers
• Control board stores the last five diagnostic codes in memory; simple push-button activation outputs the fault history to a flashing red LED
• Low constant fan allows homeowner to activate the low heat speed to efficiently circulate air throughout the home
• Self-adjusting feature automatically adjusts to high- or low-stage operation based on outside temperature without an outdoor temperature sensor
• Dual-certified for sealed combustion direct vent (2-pipe) or non-direct vent (1-pipe) applications
• All models comply with California NOx emissions standards
Cabinet Features
• Fully insulated, heavy-gauge steel cabinet with durable baked-enamel finish
• Foil-faced insulation lines the heat exchanger
• Designed for multi-position installation
• Easy-to-install top venting is standard; alternate flue/vent located on the right
• Airtight solid bottom for side-return applications and easy-cut tabs for effortless removal in bottom air inlet applications
• Convenient left or right connection for gas and electric service
• Coil and furnace fit flush for most installations
- GME95 Series Installation Instructions(PDF, 1.64 MB)
- GME95 Series Product Specification(PDF, 612 KB)
- GME95 Series Technical Manual(PDF, 499 KB)
- GME95 Series User Information Manual(PDF, 324 KB)
- GME95 Series Warranty(PDF, 359 KB)