100,000 BTU Furnace, 80% Efficiency, Single-Stage Burner, 2,000 CFM Multi-Speed Blower, Downflow Application
100,000 BTU Furnace, 80% Efficiency, Single-Stage Burner, 2,000 CFM Multi-Speed Blower, Downflow Application
Model: Direct Comfort DC-GDS81005CN
highlights
This is a Downflow unit. Learn about Downflow
To use LP fuel, this unit requires an LP Conversion Kit. See Accessories
The Direct Comfort by Goodman DC-GDS8 dedicated downflow (blows air into ducts located below it) gas furnaces features a patented aluminized steel tubular heat exchanger and high-efficiency hot surface ignition system. These furnaces are run-tested for heating or combination heating/cooling applications. With a heavy-gauge, reinforced, wrap-around insulated steel cabinet and durable baked enamel finish, these gas heaters can be installed in a utility room, closet, alcove, basement or attic. (Not intended for use in mobile homes.)
Important Safety Notice
Features
- Operates as a natural gas furnace out of the box, and can be easily converted to a propane furnace with optional propane conversion kit (see Accessories tab).
- Corrosion-resistant, aluminized-steel furnace tubular heat exchanger
- Designed for dedicated downflow installations
- Energy-saving, reliable furnace hot surface ignition system with patented adaptive learning algorithm to maximize igniter life
- Aluminized furnace steel inshot burners
- Energy-saving PSC, multi-speed, direct drive furnace blower motor
- Heater has quiet, corrosion-resistant induced draft blower assembly
- Integrated furnace control with diagnostics
- Low voltage terminal blocks
- Multiple flame roll-out switches, blower door safety switch, outlet air-limit switch and pressure switch for proof of combustion air
- 40VA transformer for heating and air conditioning control service
- Combination redundant furnace gas valve and regulator
- A rotating combustion air blower (DC-GMS8) that provides the option of venting the furnace through the top, right-hand side or left-hand side
- Completely assembled, factory run-tested furnace for heating or combination heating/cooling application
- Specific Direct Comfort by Goodman furnace models comply with California NOx Standards (models that end in "X")
- Heavy-gauge, reinforced, fully insulated steel cabinet with durable baked-enamel finish
- Attractive architectural gray paint finish
- Foil-face insulation lines the furnaces' heat exchanger compartment
- Coil and furnace fit flush for easy installation
- Convenient left or right connection for gas and electric service
- This gas furnace has removable, solid-bottom block off
Specs
System Information
Configuration
Downflow
Fuel Type
LP Capable (Kit Required) / Natural Gas
Efficiency
Efficiency (% AFUE)
80 %
Performance
Maximum Input BTU
100000 BTU
Maximum Heating Capacity
80000 BTU
Maximum CFM
2037 @ 0.5
Blower Cooling Capacity
3 / 3.5 / 4 / 5 Tons
Blower Type
Multi-Speed
Burner Stages
Single
Electrical Information
Frequency
60 Hz
Voltage Phase
1
Maximum Overcurrent Protection (Breaker)
15 Amps
Voltage
120 Volts
Product Dimensions
Width
21.000000000 Inches
Depth
28.000000000 Inches
Height
33 3/8 Inches
Cabinet/Chassis Size
C
Product Weight
175 lbs
Shipping Weight
175 lbs
Important Measurements
Vent Connection
4 Inches
Supply Air Opening Size
19 1/2 x 19 5/8 Inches
Flue Pipe Diameter
4
Warranty
Heat Exchanger Warranty
Lifetime
Unit Replacement Warranty
10 Years
Parts Warranty
10 Years
Certifications
California Approved Furnace
No
Ultra-Low NOx
No
Qualifies for Govt. Money
No
ENERGY STAR® Certified
No
Documents
- Goodman GMS8, GDS8, GHS8 Brochure(PDF, 956 KB)
- GME8, GMH8, GDH8, GMS8, GDS8, GHS8 Install Instructions(PDF, 1.28 MB)
- Goodman GDS8 Technical Information(PDF, 163 KB)
- Goodman GDS8 Warranty Information(PDF, 358 KB)
- Standard AC Wiring Diagrams(PDF, 2.49 MB)
- Goodman Furnace User Manual(PDF, 324 KB)
- Goodman GMS8 - GDS8 - GHS8 Spec Sheet(PDF, 1.11 MB)
Reviews
Let's Talk
Get expert assistance from our team
Call our product specialists at: (800) 865-5931
Open Now